A standard UNIC Stainless Cylinder® (Ø80 - Ø125) is equipped with a permanent magnet and adjustable end stroke-cushioning. Standard UNIC Stainless Cylinder® is fitted with nitrile rubber (NBR) / polyurethane (PU) packings and POM piston.
Max pressure: 10 bar
Temperature: -20°C to +80°C
Standard stroke: 10-500 mm.
Standard DIN/ISO 15552
This cylinder is designed according to standard DIN/ISO 15552 and can replace other cylinders designed according to DIN/ISO 15552.
Materials
Piston rod, mounting accessories, tube,
end caps and adapter: AISI 304 / (EN 1.4301)*
Piston: POM / Aluminium
Wiper: Nitrilgummi / Polyurentan
O-rings: Viton
*Available in AISI 316L (EN 1.4404
Magnet for sensing
All cylinder are standard fitted with a magnet. By using a reed switch, it is possible to detect the piston position.
Adjustable cushioning
With the right kind of end cushioning, you can increase the efficiency of your entire pneumatic system. To adjust the braking effect with the adjustable screw, which is mounted on the cylinder.
Cylinder with extra-high chemical resistance
When ordering a cylinder with high resistance to chemicals, add the letter ’’C’’ to the end of the product number.
Heat-resistant +150°
A heat-resistant UNIC Stainless Cylinder® can run in ambient temperatures up to +150°C. When ordering a heat-resistant cylinder, add the letter ’’H’’ to the end of the product number.
Adapter
It may be advantageous to fit an extra front adapter if the cylinder is used in an aggressive environment that leaves deposits on the piston rod. The adapter is, therefore, fitted with a highly chemical-resistant and hard scraper made of PTFE. When ordering a cylinder with adapter, add the letter „A1 or A2“ to the end of the product number.
Cylinder with spring
All cylinders are available as single action (ON request).
Assembly
All cylinders are assembled by thread and are therefore serviceable.
Please note: All measurements are for 0,0 mm stroke.
Rear cap with thread for mounting.
Rear cap with swivel mounting. (on demand)